Toro Workman HD Series - Page 129

Workman HD Series Page 6 − 59 Drive Train
10.Disassemble PTO intermediate shaft:
A. Use a bearing puller to remove bearing if neces-
sary.
1
1. Bearing
Figure 120
11.Disassemble PTO output shaft:
A. Use a bearing puller to remove bearing.
B. Remove gear and retaining ring.
C. Remove retaining ring and thrust washer.
D. Use a bearing puller to remove bearing if neces-
sary.
1. Bearing
2. Gear
3. Retaining ring
4. Retaining ring
5. Thrust washer
6. Bearing
7. Output shaft
Figure 121
1
2
3
7
6
4
5
1. Bearing
2. Gear
3. Retaining ring
4. Retaining ring
5. Thrust washer
6. Bearing
7. Output shaft
Figure 122
Drive Train