Workman HD SeriesPage 6 − 68Drive Train
10.Install PTO cover:
A. Insert new oil seal into PTO cover. Apply multi−
purpose grease to lip of oil seal.
B. Insert alignment pins into PTO housing.
C. Apply silicone sealant onto mating surface of
PTO cover.
D. Install PTO cover. Secure cover with cap screws,
nut and lock washers. Torque fasteners from 18 to
22 ft−lb (24.5 to 29.5 N−m).
11.Install PTO to transaxle (see PTO Removal and
Installation in this chapter).
18.5 to 22 ft−lb
(24.5 to 29.5 N−m)
Figure 143
To Next Page
Loading...
