Toro Workman HD Series - Hood

Workman HD SeriesPage 7 − 40Chassis
Hood
1. Hood
2. Clip (3 per headlight)
3. Headlight (2)
4. Bumper
5. Bumper bracket
6. Cover
7. Operator frame
8. Hood attachment tab
Figure 32
FRONT
RIGHT
3
6
5
1
4
2
7
8
8
8
8
Removal (Fig. 32)
1. Park vehicle on a level surface, shut engine off and
apply the parking brake. Remove key from ignition
switch.
2. Grasp hood at headlight openings and carefully pull
hood away from operator frame.
3. Unplug the wire harness connector from the two (2)
headlights.
4. Remove hood from vehicle.
Installation (Fig. 32)
1. Position hood to operator frame.
2. Plug the wire harness connector to the two (2) head-
lights.
3. Secure hood to frame by pressing hood attachment
tabs to dash and bumper.