Toro Z Master 3000 SERIES - Stopping the Machine; Adjusting the Height of Cut

G008953
Figure25
StoppingtheMachine
Tostopthemachine,movethetractioncontrolleversto
neutralandmovetolockedposition,disengagethepower
takeoff(bladecontrolswitch(PTO),andturntheignition
keytooff.
Settheparkingbrakewhenyouleavethemachine;referto
SettingtheParkingBrakeinOperation.Remembertoremove
thekeyfromtheignitionswitch.
CAUTION
Childrenorbystandersmaybeinjuredifthey
moveorattempttooperatethemachinewhileitis
unattended.
Alwaysremovetheignitionkeyandsettheparking
brakewhenleavingthemachineunattended,even
ifjustforafewminutes.
AdjustingtheHeightofCut
UsingtheTransportLock
Thetransportlockhastwopositionsandisusedwiththe
deck-liftpedal.Thereisalockpositionandaunlockposition
forthetransportposition.Thetransportlockisusedwiththe
deck-liftpedal.RefertoFigure26
22