Toro Z Master 4000 Series - Start the Engine and Drive to a Flat Area; Check the Oil Level Again; Drain the Oil from the Engine; Refer to Changing

6. Slowly pour approximately 80% of the specied
oil into the ller tube and slowly add the
additional oil to bring it to the Full mark ( Figure
63 ).
g194610
Figure 63
7. Start the engine and drive to a at area.
8. Check the oil level again.
Changing the Engine-Oil Filter
1. Drain the oil from the engine; refer to Changing
the Engine Oil ( page 49 ) .
2. Change the engine-oil lter ( Figure 64 ).
g008804
g027477
Figure 64
Note: Ensure that the oil-lter gasket touches
the engine, and then turn the oil lter an extra
3/4 turn.
3. Fill the crankcase with the proper type of new
oil; refer to Engine-Oil Specications ( page 48 ) .
Servicing the Spark Plug(s)
Service Interval : Every 200 hours —For Kohler
Engines—check the spark plug(s).
Every 500 hours —For Kohler Engines—replace
the spark plug(s).
T ype: Champion XC12YC
Air Gap: 0.76 mm (0.030 inch)
50