Toro Z Master 74958 - Mower Deck Maintenance; Leveling the Mower Deck

g008968
Figure85
Bottomviewofthemachine
1.Filterlocations
2.Hydrauliclter
6.Applyathincoatofhydraulicoiltotherubber
gasketonthereplacementlter(Figure85).
7.Installthereplacementhydrauliclter.
8.Installthepump-drivebeltandthemowerbelt.
9.Removethejackstandsandlowerthemachine
(Figure84).
10.Addoiltothehydraulicreservoirandcheckfor
anyleaks.
11.Cleanupanyspilledoil.
12.Starttheengineandletitrunforabout2minutes
topurgeairfromthesystem.
13.Shutofftheengineandcheckforleaks.
14.Checktheoillevelwhiletheoiliscold.
15.Ifrequired,addoiltothehydraulicreservoir.
Note:Donotoverll.
MowerDeck
Maintenance
LevelingtheMowerDeck
SettingUptheMachine
Note:Ensurethatthemowerdeckislevelbefore
matchingtheheightofcut(HOC).
1.Positionthemoweronaatsurface.
2.Disengagetheblade-controlswitch(PTO),move
themotion-controlleverstotheNEUTRAL-LOCK
position,andsettheparkingbrake.
3.Shutofftheengine,removethekey,andwait
forallmovingpartstostopbeforeleavingthe
operatingposition.
4.Checkthepressureofthedrivetires.
Note:Properinationpressureforthetiresis
90kPa(13psi).
5.Positionthemowerdecktothe76mm(3inch)
height-of-cutposition.
LevelingtheDeck
1.Positionthemoweronaatsurface.
2.Shutofftheengine,waitforallmovingpartsto
stop,removethekey,andengagetheparking
brake.
3.Checkthepressureinthedrivetires.
Note:Properinationpressureforthetiresis
90kPa(13psi).
4.Positionthetransportlockinthelatching
position.
5.Pushthedeck-liftpedalallthewayforward
sothedecklatchesatthe14cm(5-1/2inch)
transportposition(Figure86).
63