12.Toadjustthesingle-pointsystem,loosenthe
2boltsatthebottomoftheheight-of-cutplate
(Figure89).
g027345
Figure89
1.Boltsatthebottomoftheheight-of-cutplate
13.Ifthedeckistoolow,tightenthesingle-point
adjustmentboltbyrotatingitclockwise.If
thedeckistoohigh,loosenthesingle-point
adjustmentboltbyrotatingitcounterclockwise
(Figure90).
Note:Loosenortightenthesingle-point
adjustmentboltenoughtomovethe
height-of-cutplatemountingboltsatleast1/3
thelengthoftheavailabletravelintheirslots.
Thisregainssomeupanddownadjustmenton
eachofthe4decklinks.
g017036
Figure90
1.Single-pointadjustmentbolt
14.Tightenthe2boltsatthebottomofthe
height-of-cutplate(Figure89).
Note:Formostconditions,adjusttheback
bladetip4mm(1/4inch)higherthanthefront.
15.Torquethe2boltsto37to45N∙m(27to33ft-lb).
16.Onbothsidesofthedeck,measurefromthe
levelsurfacetothebacktipoftheblade(postion
B)asshowninFigure87.
Note:Themeasurementshouldread8.3cm
(3-1/4inches)
17.Fine-tunethescrewadjusterbyturningittoget
8.3mm(3-1/4inches)height(Figure88).
Note:T oincreasetheheight,turnthe
adjustmentnutclockwise;todecreasethe
height,turnitcounterclockwise.
18.Measureuntilall4sidesarethecorrectheight.
19.Tightenallthenutsonthedeck-lift-arm
assemblies.
20.Lowerthedischargechute.
65
To Next Page
Loading...
