Toro Z Master 7500-D Series - Gearbox Replacement

6-23
Z Master 7500-D Series Service Manual
March 2018 - Digital Edition
Table of Contents
DECK
Deck
Gearbox Replacement
Removal
1. Park the machine on a level surface, disengage the PTO and set the parking brake. Stop the engine, wait for all
moving parts to stop and remove the key.
2. Remove all belts, see “Belt Removal,” chapter 6, page 6-20.
3. Remove the three lock nuts, at washers, and isolators from the gear box mount (Figure 20).
4. Remove the gearbox.
Installation
1. Install the gearbox onto the deck.
2. Install the three lock nuts, at washers, and isolators to the gear box mount.
3. Install all belts, see “Belt Installation,” chapter 6, page 6-22.
Figure 20