6-26
Z Master 7500-D Series Service Manual
March 2018 - Digital Edition
Table of Contents
DECK
Deck Hydraulics (Deck Fold Cylinder) (Cont.)
Installation
1 Install the deck fold cylinder onto the deck.
2. Install the locking cotter pins (two on each cylinder) on both ends of the deck fold cylinder.
3. Install the screws securing the deck-stop bracket to the machine.
4. Verify the hydraulic lines are cleaned from debris, attach the hydraulic lines to the lift cylinder.
5. Install the center oor pan.
6. Install the two lynch pins securing the outer belt guard to the deck. Repeat for opposite side.
7. Install the two lock nuts and two carriage bolts securing the inner belt guard. Repeat for opposite side.
8. Perform purge procedure, see “Charging the Hydraulic System,” chapter 7, page 7-17.
9. Test run to operating temperature and test deck operation.
To Next Page
Loading...
