6-30
Z Master 7500-D Series Service Manual
March 2018 - Digital Edition
Table of Contents
DECK
Deck Wings (Cont.)
Installation
1. Roll the wing towards the center deck section and align.
2. Install the front and rear deck pins and secure with bolts.
3. Install the locking cotter pin to the outer wing ram lift pin.
4. Install the two cap screws securing the wing stop bracket.
5. Lower the center deck.
6. Install the rear tire, remove the jack stand.
7. Install the belt, see “Belt Installation,” chapter 6, page 6-22.
8. Perform purge procedure, see “Charging the Hydraulic System,” chapter 7, page 7-17.
9. Test run to operating temperature and test deck operation.
To Next Page
Loading...
