Toro Z Master 7500-D Series - Page 86

5-33
Z Master 7500-D Series Service Manual
March 2018 - Digital Edition
Table of Contents
CHASSIS
Chassis
Motion Control Assembly (Cont.)
Removal (Cont.)
8. Remove the bolt securing the pivot hub and the LH motion control to the frame (Figure 24).
9. Remove the pivot hub from the LH motion control (Figure 25).
10. Remove the wire harness anchor from the LH motion control.
11. Remove the neutral switch from the LH motion control.
12. Remove the carriage bolt and nut retaining the leaf spring to the LH motion control.
13. Remove the jam nut from the LH motion control lever.
14. Remove the nut, two spring washers, flat washer and LH motion control lever from the LH motion control.
Figure 24
Figure 25