Toro Z Master 7500-D Series - Adjusting the Motion Control Neutral Lock Pivot

5-35
Z Master 7500-D Series Service Manual
March 2018 - Digital Edition
Table of Contents
CHASSIS
Chassis
Adjusting the Motion Control Neutral Lock Pivot
NOTE: The anged nut can be adjusted to obtain a more desired motion control lever resistance when
moving it to the neutral lock position (Figure 26).
1. Loosen the jam nut.
2. Tighten or loosen the anged nut to the desired feel. For more resistance, tighten the ange nut. For less
resistance, loosen the ange nut.
3. Tighten the jam nut.
A
B
Figure 26