Toro Z Master G3 3000 Series - Page 105

HYDRAULIC SYSTEM
5-10 Toro Z Master G3 3000/5000/6000 Series Service Manual
5
6. Loosely install 3 bolts and nuts securing the cradle
to the UHT that was not serviced. The oor jack may
have to be repositioned to align holes (Fig. 298).
7. On the side of the machine being serviced, tighten
the 3 bolts securing the cradle to the UHT and the 2
bolts securing the UHT to the frame (Fig. 299).
Fig. 297 PICT-8638a
Fig. 298 PICT-8615a
Fig. 299 PICT-8640a
A. Cradle to UHT nuts
B. UHT mounted to frame bolts
8. Tighten the 3 bolts and nuts securing the cradle to
the UHT that was not serviced (Fig. 300).
Fig. 300 PICT-8615a
4. Raise the mower deck to the 3” (7.6cm) height-of-cut
position.
5. On the side of the machine that was serviced,
loosely install 2 mounting bolts, coming from the
top down, through the frame and into the UHT (Fig.
297).
A
B
B
A
A