Toro Z Master G3 3000 Series - Page 85

ENGINE
4-2 Toro Z Master G3 3000/5000/6000 Series Service Manual
4
7. Loosen the cable clamp and remove the throttle
cable (Fig. 224).
Fig. 224 DSCN-4253a
8. Remove the z-bend end of the cable from the throttle
arm assembly (Fig. 225).
Fig. 225 DSCN-4258a
6. Remove the 2 nuts retaining the rear guard to the
frame and 1 carriage bolt and nut retaining the
mufer guard to the rear guard (Fig. 223).
Fig. 223 DSCN-0012a
5. Remove the 3 carriage bolts and nuts retaining the
LH bumper to the frame and rear guard (Fig. 222).
Fig. 222 DSCN-0004a