Toro Z Master Professional 3000 Series - Page 60

g027343
Figure89
1.Deck-liftpedal
3.Transportlock
2.Height-of-cutpin
6.Inserttheheight-adjustmentpinintothe7.6cm
(3inch)cutting-heightposition.
7.Releasethetransportlockandallowthedeckto
lowertothecuttingheight.
8.Raisethedischargechute.
9.Onbothsidesofthedeck,measurefromthe
levelsurfacetothefronttipoftheblade(Position
A);refertoFigure90.
Note:Themeasurementshouldread7.6mm
(3inches).
g009196
Figure90
1.7.6cm(3inches)at
positionAiscorrect
3.Measurehere,fromthe
bladetip,tothehard
surface
2.8.3cm(3–1/4inches)at
positionBiscorrect
4.MeasureatpositionAand
Bonbothsides
10.Ifneeded,loosentheangedlocknutontheside
oftheyokeandthejamnutontop.Fine-tune
theadjusterscrewbyturningittoget7.6mm(3
inch)height(Figure91).
Note:Toincreasetheheight,turntheadjuster
screwclockwise;todecreasetheheight,turnit
counterclockwise.
g010251
Figure91
1.Flangedlocknut3.Jamnut
2.Adjusterscrew4.Yoke
11.Ifthefrontdecklinksdonothaveenough
adjustmenttoachievetheaccuratecutheight,
youcanusethesinglepointadjustmentcanbe
utilizedtogainmoreadjustment.
12.Toadjustthesinglepointsystem,loosenthe2
boltsatthebottomoftheheight-of-cutplate.
RefertoFigure92.
60