Toro Z Master Z597 - Cooling System; Removing the Radiator

5-21Z Master Z597 Diesel Service Manual
5
44. Install the rear heat shield (Fig. 294).
Fig 294 DSC-2370
Fig 295 DSC-2505
45. Install the engine hood assembly with clevis pins,
washers and hairpins (Fig. 295).
ENGINE
DANGER! Discharge of hot pressurized coolant or
touching hot radiator and surrounding
parts can cause severe burns.
• Do not remove radiator cap or open drain petcock
when the engine is hot. Always allow the engine
to cool at least 15 minutes or until the radiator cap
is cool enough to touch without burning your hand
before removing the radiator cap or opening drain
petcock.
• Do not touch radiator and surrounding parts that are
hot.
1. Disconnect the battery negative cable.
Slip the hood lanyards on the radiator support bolts
(Fig. 296).
Fig 296 DSC-2410
Removing the Radiator
Cooling System