Toro Z Master Z597 - Mower Jackshaft and Pulley Assembly; Right Hand Mower Idler Assembly Removal

7-32 Z Master 597 Diesel Series Service Manual
7
Mower Jackshaft and Pulley
Assembly
The jackshaft housing and bearings are not available
as separate components. Listed below is a view of the
components of the jackshaft and pulley assembly (Fig.
501).
Fig 501 DSC-2714
A. Retaining Nut D. Jackshaft Assembly
B. Spring Washer E. Jackshaft Pulley
C. Bottom Spacer F. Jackshaft
Guard
Fig 503 DSC-2607
2. Remove the right side mower drive belt by inserting
a 3/8” drive ratchet with a 6” long extension into the
square cut hole in the idler bracket. Pull back to
relieve the tension on the belt. Slip the belt off the
idler pulley (Fig. 503).
Fig 502 DSC-2595
1. Loosen the 4 bolts holding the rear bumper
assembly and remove from the unit (Fig. 502).
Note: Item C., Bottom Spacer Guard is recessed.
Make sure the recessed portion of the guard
is facing the jackshaft bearing.
A
B
C
D
E
F
Right Hand Mower Idler Assembly
Removal
MOWER DECKS