7-35Z Master 597 Diesel Series Service Manual
7
MOWER DECKS
2. Install the belt tensioner spacer, washer, bolt, and
extension spring (Fig. 512).
Fig 512 DSC-2725
Fig 514 DSC-2716
4. Install the RH idler pulley (Fig. 514).
Fig 513 DSC-2720
3. Insert the ratchet with 6” extension into the square
hole in the idler arm. Pull back on the idler arm and
install the idler stop bolt and spacers. Slowly release
the idler arm until it contacts the stop bolt and
spacers. Install the ange nut to the stop bolt and
tighten (Fig. 513).
Fig 515 DSC-2607
5. Insert a ratchet with a 6” extension into the square
hole in the idler bracket. Pull back relieving the
tension on the idler pulley and install the mower
drive belt (Fig. 515).
To Next Page
Loading...
