Toro Z Master Z597 - Page 35

3-14 Z Master Z597 Diesel Service Manual
3
3. Route the throttle cable through the tie strap located
on the engine lifting bracket (Fig. 054).
Fig 056 DSC-1605
4. The throttle cable is then routed around the fuel
pump injector lines and through the swivel clamp.
Note: The cable wire should be routed through the
swivel clamp, with the swivel clamp washer
located under the cable wire (Fig. 055).
6. Install control panel to the fuel tank mount location
(Fig. 057).
Fig 055 DSC-1600
Fig 057 DSC-1606
Fig 054 DSC-1599
5. Install the throttle cable on the inside of the casing
clamp, DO NOT tighten (Fig. 056).
CHASSIS
A
B
A. Cable wire B. Washer