Toro Z Master Z597 - Page 36

3-15Z Master Z597 Diesel Service Manual
3
7. Install throttle control knob and position throttle
control lever to the idle position (Fig. 058).
Fig 058 DSC-1608
Fig 060 DSC-1616
9. Tighten the cable housing clamp (Fig. 060).
8. Position the throttle cable swivel clamp until 1/4”
(6.35mm) of the throttle cable wire protrudes through
the opposite end of the clamp. Carefully tighten the
swivel clamp screw (Fig. 059).
10. Move the throttle control lever to the Full speed
position. Verify injector pump arm contacts the high
speed stop screw (Fig. 061).
Fig 059 DSC-1614
Fig 061 DSC-1617
CHASSIS