Toro Z Master Z597 - Deck Lift Lever Installation

3-26 Z Master Z597 Diesel Service Manual
3
CHASSIS
14. If the lift lever contacts the RH motion control plate,
tilt and hold the oor pan assembly slightly forward.
Move the RH motion control lever out of the neutral
lock position and push it in the full forward position.
Using a tie strap or wire, tie the oor pan assembly
to the motion control arm to hold the oor pan
assembly in place (Fig. 096).
Fig 096 DSC-1665
15. Carefully slide the lift lever assembly out of its
carrier frame pivot (Fig. 097).
Fig 097 DSC-1667
Deck Lift Lever Installation
1. For ease of installation, make sure deck lift arm
plates, bushing, and hardware are installed on the
lift lever grip assembly prior to installation as shown
(Fig. 098).
Fig 098 DSC-1668
2. Install lift lever assembly into front frame pivot
location (Fig. 099).
Fig 099 DSC-1670
A. Plate C. Bushing
B. Nut D. Bolt
A
A
B
C
D