Toro Z Master Z597 - Page 49

3-28 Z Master Z597 Diesel Service Manual
3
CHASSIS
Fig 104 DSC-1680
8. Raise lift lever until deck mount swivels rest against
deck rod jam nuts. Install HOC pin into deck lift plate
height of cut holes to hold lift lever in this position
(Fig. 105).
Fig 105 DSC-1681
7. Align rear deck mount swivels with ends of deck lift
rod (Fig. 104).
9. Install lower “stop” bolt through inner and outer deck
lift plates. Install nylock nut and tighten until hex nut
and bolt are seated rmly against the deck lift plates.
DO NOT over-tighten or deck lift plates will deform
inward causing height of cut hitch pin assembly to
bind (Fig. 106).
Fig 106 DSC-1682
10. Install hex nut on end of deck lift rod. Tighten against
deck mount swivel. Repeat procedure for opposite
side deck lift rod (Fig. 107).
Fig 107 DSC-1683
A
A. HOC Pin