Toro Z Master Z597 - Page 71

4-18 Z Master Z597 Diesel Service Manual
4
HYDRAULIC SYSTEM
Fig 179 DSC-2071
3. Remove the two knobs located on the engine access
panel assembly. Remove the engine belt shield and
the engine access panel (Fig. 179).
Fig 178 DSC-2371
2. There are 6 bolts and nuts, 3 on each side, retaining
the radiator and fan mounting plate assembly to the
right and left upper frame assembly. Loosen, DO
NOT remove, the two bolts and nuts at the front
right and left side; this will allow you to pivot the
assembly upward. Remove the rear 4 bolts and nuts
(Fig. 178).
A. Remove B. Loosen
B
A
A
4. Loosen and remove the clamp on the hydraulic
return line located on the left side of the unit (Fig.
180).
Fig 180 DSC-2372
Fig 181 DSC-2374
5. Remove the tie strap holding the throttle control
cable. Remove the clamps holding the inlet cooling
hose and the overow hose to the radiator (Fig.
181).