4-19Z Master Z597 Diesel Service Manual
4
HYDRAULIC SYSTEM
6. Tilt the fan mounting plate assembly and the
radiator up approximately 5” (12.7cm) to get enough
clearance to remove the hydraulic motor fan.
Caution: Do not raise too far, as damage could
occur to some of the hydraulic lines and
cooling hoses.
Use a nylon tie down strap between the fan
mounting plate and the center section of the ROPS
Bar to hold in place (Fig. 182).
Fig 182 DSC-2377
7. Place a small oil drain pan on top of the engine.
Loosen and remove the hydraulic lines to the
hydraulic fan motor (Fig. 183).
Fig 183 DSC-2378
8. Loosen and remove the 4 bolts and nuts holding the
fan motor mount (Fig. 184).
Fig 184 DSC-2379
9. Remove the fan motor mount from the fan mounting
plate (Fig. 185).
Fig 185 DSC-2380
To Next Page
Loading...
