5-11Z Master Z597 Diesel Service Manual
5
ENGINE
Engine Installation
1. Before installing the engine, make sure the large
washer is located on top of the rear engine mount
isolator (Fig. 258).
Fig 258 DSC-2481
2. Carefully lower the engine into the frame of the unit.
The engine will have to be turned slightly so the
mufer clears the right rear radiator support bracket
and to clear the engine drive pulley, pump idler
pulley and the RH pump pulley.
3. Install the bolt and nut on the engine rear mount, do
not tighten (Fig. 259).
Fig 259 DSC-2482
Fig 257 DSC-2480
41. Carefully lift the engine with the hoist. As the engine
is being lifted out, turn it slightly to gain clearance
between the engine drive pulley, pump idler pulley,
and the RH pump pulley. Also, you may have to
turn the engine so the mufer clears the right rear
radiator support bracket (Fig. 257).
To Next Page
Loading...
