35
Where to Add Grease
Lubricate the grease fittings as shown on the Check
Service Reference Aid decal (Fig. 43).
Figure 43
Where to Add Light Oil or Spray
Lubrication
Lubricate the machine in the following areas with spray
type lubricant or light oil. Lubricate every 160 hours.
• Seat switch actuator.
• Brake handle pivot.
• Brake rod bushings.
• Motion control bronze bushings.
Greasing the Spindles
The cutting unit must be lubricated weekly or every 25
hours. Refer to the Service Interval Chart on page 27.
Grease with No. 2 general purpose lithium base or
molybdenum base grease.
Important Make sure cutting unit spindles are full of
grease weekly.
1. Disengage the PTO, move the motion control levers to
the neutral locked position and set the parking brake.
2. Stop the engine, remove the key, and wait for all
moving parts to stop before leaving the operating
position.
3. Grease the three spindle bearings under the pulleys
until grease comes out the lower seals (Fig. 44).
4. Grease the fittings on the push arms (Fig. 44).
m–6822
Figure 44
To Next Page
Loading...
