4th Screen: CONTROLLER SETTINGS
Before your first ride you should tune your controller according to your
riding preferences and the battery you are using.
The app allows the user to enter certain values that can potentially harm
the battery, motor or other parts. We suggest you to use the settings that
have been preset in the app by default.
14
1-Sport & Eco Mode: Choose the desired mode by
pressing the mode button on the handle bar of your
bike.
After that, set the parameters in a tab according to the
chosen mode (Sport/Eco).
2-Estimated Power: Power estimate sets itself
automatically, according to the chosen settings. It is
calculated by taking into account the battery current,
motor current and voltage (voltage is set according to
the battery type).
3-Motor Current: Motor Current affects the torque of
the motor. It is most noticeable at a lower speed.
4-Battery Current: Battery Current affects the
maximum power. It also affects torque, which is most
noticeable at medium and higher speeds.
5-RPM/Speed: Set the maximum speed limit. In case
you choose ∞your speed is not limited.
6-Regen Type: The Controller supports the regen from
the original SurRon brake signal and the regen from the
throttle release. By moving either slider, set the
amount of the regenerated current. Both regen types
can be activated simultaneously. In case the battery is
fully charged, the LOW REGEN warning will appear on
the 1st screen.
7-Field Weakening: This option will increase the top
speed of your bike, but it comes with its own set of
advantages and disadvantages:
Advantages: more speed, more torque on high speed
Disadvantages: less range, increased motor
temperature.
We recommend setting the current to below 50 A to
minimize potential drawbacks.
WWW.TORPMOTORS.COM
Note that the TC500 controller is not an original SurRon/Segway part, therefore
you are using it strictly at your own risk. The damages that are caused by using the
controller are solely your responsibility.
To Next Page
Loading...