TORP TC500 - Introduction

To Next Page

To Previous Page

IMPORTANT.

Please read and carefully follow the instructions in this manual. The TC500 controller must always

be used with a stock SurRon/Segway circuit breaker (fuse)! Not using the circuit breaker with the

TC500 controller is dangerous and can cause serious damage!

Use only tools and screws that came with the controller. Using the tools and screws that were not

included in the parcel, not following these instructions, or not using the circuit breaker, can cause

serious damage to you and your bike.

INTRODUCTION.

TC500 controller is compatible with:

-SurRon Light Bee/Segway X260

-Torp Motor TM25

-SurRon Ultra Bee.

TC500 is not compatible with Segway X160. TC500 controller is also not compatible with motor

model number P/N: 11100-YQ2A-0100. Please check your motor model number before installing

the TC500 controller. In general, all SurRon/Segway X260 motors, manufactured after 2018 are

compatible with the TC500 controller.

TC500 controller is compatible with both versions of the stock display (L1 E & the off-road version).

Both speed and the distance are displayed on it. For the additional options, like battery monitoring

and settings, you will have to use your smartphone or buy a Torp Display, that is sold separately.

This is a plug&play controller that needs no previous knowledge of electronics and programming for

installation and setup. Everything needed for successful installation is included in the box.