Toshiba 1600 Series - RS-232 C Communication Interface; RS-232 C Control and Data; RS-232 C Connector Pin Assignment

UPS Connections
Communication Interface (Cont'd)
RS-232C
The RS-232C serial communication interface is available through a DB9 female connector
located on the back side of the UPS (see page 44 for DB9 connector location). This
interface allows control of the UPS from a personal computer running special Toshiba software.
The computer and the UPS are connected through a serial RS-232C communication port.
The available data from the UPS, via the RS-232C communication link, is shown below:
Input voltage
Output voltage
Output current
Battery voltage
Input frequency
Output frequency
Utility power OK
Low battery voltage detected
UPS in BYPASS mode
UPS in NORMAL mode
Input and output frequency synchronized
UPS fault occurred
DC bus overcurrent
DC bus overvoltage
DC bus undervoltage
Input overcurrent
Overheat
Overload being timed
Overload (allowable time exceeded)
Output overvoltage (during NORMAL mode)
Output undervoltage (during NORMAL m
ode)
16
Pin I/O Symbol Description
1 This pin is not used
RS-232C Connector Pin Assignment
3
5142
9687
DB9 Female Connector Outline
(facing connector)
2 RXD Receive data
3 TXD Transmit data
4 DTR Data terminal ready
5 Signal ground
DSR Data set ready
6
7 RTS Request to send
8 CTS Clear to send
9 This pin is not used
Input
Output
Output
Input
Output
Input
SG
Operating conditions
UPS operating status
(described as yes or no)
'Fault details
(described as occurred
or not occurred)
The connector pin assignment and female connector outline are illustrated below.
TOSHIBA