Toshiba 1600 Series - Display Screens - Data Setting Screens; Key Lock and Buzzer Volume Setting; LCD Sleep Timer and Auto Run Setting; Communication Mode and Baud Rate Settings

30
TOSHIBA
Display Screens (cont'd)
Data Setting Screens
The 'Data Setting Screens' sequentially display the data variables that can be set. Each variable is
displayed as the 'down' arrow key is pressed. The 'up' arrow can also be pressed at any time to back
up to the previous screen:
##/##/####(###)
TO CHANGE:SELECT
BUZZER VOLUME: 2
TO CHANGE:SELECT
TIME ##:##:##
TO CHANGE:SELECT
KEY LOCK:DIS
TO CHANGE:SELECT
LCD SLEEP: 3MIN
TO CHANGE:SELECT
BATTERY TEST
DATA SET:SELECT
AUTO RUN: NO
TO CHANGE:SELECT
AUTO RETRAN: YES
TO CHANGE:SELECT
REMOTE: BYPASS
TO CHANGE:SELECT
COMM MODE: RS232
TO CHANGE:SELECT
BAUD RATE: 1200
TO CHANGE:SELECT
INI BAT TST: YES
TO CHANGE:SELECT
AUTO BAT TST: NO
TO CHANGE:SELECT
PERFORM BAT TEST
PUSH SELECT
VOLTAGE ADJ: +0
TO CHANGE:SELECT
CLEAR TIMER SET
DEFAULT SETTINGS
PUSH: SELECT
1) If the key is pressed from any of the
Data Setting Screens then the return is to the
UPS Operation screen in the UPS Start-up
Screens (See page 27).
2) For explanations on changing each of these
settings when the key is pressed
(See pages 31 - 35).
3) When the automatic battery test mode has been
set to YES then the following screen is displayed
when scrolling through the data setting screens:
NOTE: The data variables shown for each screen
indicate the default data set at the factory
(unless previously changed by the user).
See notes 1, 2
See notes 1, 2
See notes 1, 2
See notes 1, 2
See notes 1, 2
See notes 1, 2
See notes 1, 2
See notes 1, 2
See notes 1, 2
See notes 1, 2
See notes 1, 2, 3
See notes 1, 2
See notes 1, 2
See notes 1, 2
See notes 1, 2
See notes 1, 2
See notes 1, 2
Set
Monitor
Shift
Select
INTERVAL: 10DAY
TO CHANGE:SELECT
See notes 1, 2