Toshiba 26W300P - Picture Display Modes

28
Scrolling the picture in CINEMA mode/Auto 4:3 Default
Notes:
AUTO 4:3 DEFAULT is available only
for AUTO picture size setting.
In COMPONENT mode, AUTO
4:3
DEFAULT is available only for
480i/576i mode.
•
•
Scrolling the picture in CINEMA mode
When the CINEMA mode is selected, you can adjust the vertical
picture position.
Note:
You cannot move the picture vertically in any of the other picture
modes.
1
Press MENU, the menu will
appear on the screen. Press
or to select (SETUP)
menu. Press
or to select
VERTICAL POSITION, then
press ENTER.
EXIT : END MENU: RETURN
AUTO TUNING
MANUAL TUNING
CH ALLOCATION
LANGUAGE
ENGLISH
VERTICAL POSITION 0
AUTO 4:3 DEFAULT
16:9
0
2
Press or to adjust the
vertical position of the picture.
To raise the picture, press
.•
VERTICAL POSITION
EXIT : END MENU: RETURN
10
To lower the picture, press .•
VERTICAL POSITION
EXIT : END MENU: RETURN
–10
Note: You can adjust the vertical position upwards by up to
+10 and downwards by up to –10.
3
Press EXIT to return to the normal screen.
Auto 4:3 Default
This option selects the default way that a 4:3 signal is shown -
either as normal ‘4:3’ or expanded in the ‘16:9’ mode, according
to your preferences.
1
Press MENU, the menu will
appear on the screen. Press
or to select (SETUP)
menu. Press
or to select
AUTO 4:3 DEFAULT, then press
ENTER.
EXIT : END MENU: RETURN
AUTO TUNING
MANUAL TUNING
CH ALLOCATION
LANGUAGE
ENGLISH
VERTICAL POSITION 0
AUTO 4:3 DEFAULT
16:9
16:9
2
Press or to select 4:3 or 16:9.
3
Press EXIT to return to the normal screen.
32L0141B_Eng.indd 2832L0141B_Eng.indd 28 6/7/2007 9:21:20 AM6/7/2007 9:21:20 AM