35
E
6. Setting of Scart socket (1) (AV1)/ (2) (AV2)
1
Press MENU, the menu will appear on the screen. Press or to select
(SETUP) menu. Press
or to select AV1 INPUT or AV2 INPUT, then press ENTER.
2
Press or to select AV, RGB or S-VIDEO.
AV: Composite signal (e.g. from VHS-Video recorder).
RGB: RGB signal (e.g. from DVD player with RGB output).
S-VIDEO: S-Video signal (e.g. from DVD player with S-Video output).
Note:
When S-VIDEO is selected, the image will not be outputted from
(2)
(AV2) SCART socket. Only the sound will be outputted.
EXIT : END MENU: RETURN
AV1 INPUT AV
AV2 INPUT AV
AV COLOUR
AUTO
RESET TV SETTING
AV
3
Press EXIT to return to the normal screen.
5. Connecting to a DVD player or other AV device with Component Video outputs
YPbPr
Component output
Audio output
Video cable (not supplied)
Audio cable (not supplied)
To COMPONENT IN
TV (Left side view)
If your DVD player (or other device) has Component Video output jacks, use a suitable set of cables
(RCA/Phono) to connect these to the Component Video inputs on this TV as shown - it can greatly enhance
the picture quality and performance. Please remember that you will also need to connect separate cables
(RCA/Phono) for the audio signals. Select the COMPONENT input mode (see page 11).
Note:
The Component Video input of this unit are for use with equipment which outputs interlaced signals (PAL:
576i/1080i or NTSC: 480i/1080i) and progressive signals (PAL: 576p/720p or NTSC: 480p/720p).
DVD player
Connection to other equipment
32L0141B_Eng.indd 3532L0141B_Eng.indd 35 6/7/2007 9:21:22 AM6/7/2007 9:21:22 AM
To Next Page
Loading...
