÷
÷
Adding channels to the TV's memory
Your TV will stop on specific channels that are stored in the TV's
channeI memory when you press ChanneI + or -. Use the steps below
to set all active channels in your area automatically.
Programming channels automatically
Your TV can automatically detect aII active channels and store them in
its memory. After the TV has stored the channels in its memory auto-
matically, you can add or erase channels manually.
To add channems automatically:
1. Press MENU, then press _ or !_ to display the SETUP menu.
2. Press _. or V untiI the TV/CABLE
seIection is highlighted.
3. Press 4 or _ to highIight either
TV or CABLE, depending on
which you use.
If you use an antenna, choose TV.
If you use cable, choose CABLE.
TVCAi_L_
CH PROGRAM START
ADD,ERASE ADD
SELECT A V ADJUST _
4. Press V to select CH PROGRAM.
5. Press 4 or _ to start channel programming. The TV will automati-
cally cycle through all the TV or Cable channels (depending on
which you selected), and store all active channels in the channel
memory.
While the TV is cyciing through the channels, the message
"PROGRAMMING NOW-PLEASE WAIT" appears.
6. When channel programming iscomplete, the message "COMPLETED"
appears.
7. Press CH + or - to view the programmed channels.
Adding and erasing channels manually
After you have programmed the channels automatically, you can add or
erase specific channels manually.
To add or erase channems manually:
1. Select the channel you want to add or erase.
If adding channels, you must select the channel to add using the
Channel Number buttons.
2. Press MENU, then press _ or
to display the SETUP menu.
3. Press A or V to highlight ADD/
TV /CABLE CABLE
ERASE.
CR PROGRAM START _,,
4. Press 4 or _ to select ADD or _ADD ERASE
ERASE, whichever function you
want to perform. SELECT AT ADJUST 4
5. Repeat steps 1-4 for other
channels you want to add or erase.
Changing channels
To change tothe nextprogrammed channel:
Press Channel V or ,&on theTV or CH + or- on the remote
control
To change toa specificchannel (programmed or unprogrammed):
Pressthe Channel Number buttons(0-9 and 100)on theremote
control,
For example, to select channel 125, press 100, 2, 5.
®6
- Channel
Numbers
- Channel +/-
- Menu
Exit
÷
16
3N42601A[E] P07-16
÷
1/24/04, 3:36 PM
To Next Page
Loading...
