20
Using the TV’s features (General)
Notes:
• The Tint may only be adjusted on a tape which has been
recorded and played back on an NTSC VCR.
• In the PC input mode (- page 25), Color, Tint and
Sharpness modes are not available.
Activating the black stretch
This function increases the strength of dark areas of the picture
which improves definition.
1 From the Picture settings menu, press or to
select Black stretch on the 2nd page.
2 Press or to select On or Off.
Note:
In the PC input mode (- page 25), this mode is not available.
Activating the MPEG NR (Noise Reduction)
If the receiving signal of MPEG is a mosquito (grained) noise
depending on the compression and conversion, the noise may
be reduced when using this function.
1 From the Picture settings menu, press or to
select MPEG NR on the 2nd page.
2 Press or to select Off, Low, Middle or High.
Note:
In the PC input mode (- page 25), this mode is not available.
Activating the DNR (Digital Noise
Reduction)
- analog only -
If the receiving signal is weak and the picture is blurry, the
picture may be improved when using this function.
1 From the Picture settings menu, press or to
select DNR on the 2nd page.
2 Press or to select Auto, Off, Low, Middle or High.
Selecting the color temperature
You can change the tone of the picture by selecting from three
preset color temperatures: Cool, Normal or Warm.
1 From the Picture settings menu, press or to
select Color Temperature on the 2nd page.
2 Press or to select mode you prefer.
Cool: Lends a blue hue to the picture.
Normal: Neutral
Warm: Lends a red hue to the picture.
Adjusting the color management
You can adjust the picture color quality by selecting from 6
base color adjustments : Red, Green, Blue, Yellow,
Magenta or Cyan.
1 Press M, then press or to display the PICTURE
menu.
2 Press or to select 3D Color management, then
press or , then press or to select On.
3 Press Q, then press or to select Base color
adjustment.
4 Press Q, then press or to select an item you want
to adjust.
5 Press , then press or to select Hue, Saturation or
Brightness.
6 Press or to adjust the settings as required.
Notes:
• If you select color management Off mode, this mode is not
available.
• In the PC input mode (- page 25), this mode is not
available.
Resetting the base color adjustment
The Reset function adjusts the base color adjustment to the
factory settings.
1 From the Base color adjustment menu, press or
to select Reset.
2 Press Q.
Using the active backlight control
In order to improve screen visibility, the active backlight
control sets the screen brightness automatically during dark
scenes.
1 From the PICTURE menu, press or to select
Active Backlight Control.
2 Press or to select On or Off.
Color Temperature
Black stretch
MENU
Back Watch TV
EXIT
On
Cool
MPEG NR
Low
Picture settings 2/2
DNR
Auto
Black stretch
On
MPEG NR
High
DNR
Auto
Color Temperature
Cool
3D Color management
On
Hue
MENU
Back Watch TV
EXIT
Red
Blue
Green
Yellow
Magenta
Cyan
Saturation Brightness
0
0
0
0
0
0
0
0
0
0
0
0
0
0
0
0
0
0
Reset
OK
Base color adjustment
Red
Brightness
0
Hue
0
Saturation
0
To Next Page
Loading...
