39
Copyright © 2005 TOSHIBA CORPORATION. All rights reserved.
(E) 32/37/HL95 *Web 213 : 276
Chapter 6: Setting up your TV
Setting the HDMI™ audio mode
To select the HDMI audio mode:
1. Press MENU and open the Setup menu.
2. Highlight HDMI Audio and press ENTER.
3. Press z y to select the HDMI audio mode (Auto, Digital,
or Analog) and press ENTER. (Auto is the recommended
mode). See “Connecting an HDMI or a DVI device to the
HDMI input” on page 19.
Setting the time and date
Note: If you already set up the TV Guide On Screen™ system,
the time and date were set automatically and you can skip this
step.
To set the time and date:
1. Press MENU and open the Setup menu.
2. Highlight Installation and press ENTER. (A new set of
Installation menu icons will appear on-screen, as shown in
step 3 below.)
Navigate
Select
Back Exit
CH RTN
EXIT
Installation
Sleep Timer
On/Off Timer
PC Settings
No
Auto
2
PC Audio
HDMI Audio
Gray Level
Setup
3. Open the Time And Date menu, highlight Start Setup, and
press ENTER.
Start Setup
Time And Date
Navigate
Select
Back Exit
CH RTN
EXIT
If you have not set up the TV Guide On Screen
™
system,
the following screen will appear. To set the time, highlight
TV Guide On Screen
™
and press ENTER. The TV Guide
On Screen
™
setup sequence will start, and the time and
date will be set automatically.
Cancel
Time And Date
Manual
TV Guide On Screen
Your TV Guide On Screen System can provide accurate
time and date information.
It is recommended you set up TV Guide On Screen
first and use it to obtain the time and date.
Note:
• If you highlight TV Guide On Screen™ (above) to set the time
and date through the TV Guide On Screen™ system and a
power outage occurs, the time and date will be updated
automatically when the power is restored.
• If you highlight Manual (above) to set the time and date
manually and a power outage occurs, you will lose the time
and date settings when the power is restored.
• If you manually set the time and date and then perform
TV Guide On Screen™ setup, the manual time and date
settings will be overridden by the TV Guide On Screen™
settings.
Analog
Digital
Auto
Navigate
Select
Back Exit
CH RTN
EXIT
Installation
Sleep Timer
On/Off Timer
PC Settings
No
Auto
2
PC Audio
HDMI Audio
Gray Level
Setup
#01E_038-041_3237HL95 5/20/05, 2:25 AM39
Black
To Next Page
Loading...
