Toshiba 32HL95 - Viewing the Cablecard Menu; Viewing the Digital Signal Meter

40
Copyright © 2005 TOSHIBA CORPORATION. All rights reserved.
(E) 32/37/HL95 *Web 213 : 276
Viewing the digital signal meter
You can view the digital signal meter for ANT 1 and ANT 2
digital TV input sources only.
To view the digital signal meter:
1. Press MENU and open the Setup menu.
2. Highlight Installation and press ENTER. (A new set of
Installation menu icons will appear on-screen, as shown in
step 3 below.)
Navigate
Select
Back Exit
CH RTN EXIT
Installation
Sleep Timer
On/Off Timer
PC Settings
No
Auto
2
PC Audio
HDMI Audio
Gray Level
Setup
3. Open the Terrestrial menu, highlight Signal Meter, and
press ENTER.
Terrestrial
Input Configuration
Channel program
Channel Add/Delete
Signal Meter
Navigate
Select
Back Exit
CH RTN EXIT
4. Use yzx • to select the antenna input and digital channel
whose signal you want to check.
Note: The physical digital channel number listed in the Signal
Meter screen may not correspond to a virtual TV channel
number. Contact your local broadcasters to obtain the RF
channel numbers for your local digital stations.
Signal Meter
Antenna 1
Physical Digital Channel 13
Virtual Digital Channel
O K
N/A
Signal Locked
0 0 Peak
To close the screen and return to the Terrestrial menu:
Highlight OK and press ENTER.
To return to normal viewing:
Press EXIT.
Viewing the CableCARD™ menu
A CableCARD
™
enables you to view encrypted digital channels.
See page 12 for connection and subscription information.
After the CableCARD
™
is inserted, a CableCARD
™
option
appears in the Applications menu, with informational screens
provided by your CableCARD
™
service (see illustrations below).
CableCard Connected -- Acquiring
channel information.
CableCard services will only operate with
cable signal connected to Antenna 1.
OK
Navigate
Select
Back Exit
CH RTN EXIT
Applications
TV Guide On Screen
Digital CC/Audio Selector
CableCARD
Conditional Access
CableCARD(tm) Status
Network Setup
CableCARD(tm) Pairing
To view the CableCARD
™
menu:
1. Press MENU and open the Applications menu.
2. Highlight CableCARD
™
and press ENTER.
3. A side menu will display. Highlight one of the side menu
items and press ENTER to display the information.
Note: The CableCARD™ menu has no user-adjustable
options and is for informational purposes only.
Chapter 6: Setting up your TV
#01E_038-041_3237HL95 5/20/05, 2:25 AM40
Black