60
Copyright © 2005 TOSHIBA CORPORATION. All rights reserved.
(E) 32/37/HL95 *Web 213 : 276
To go to a specific favorite channel, see page 38.
Tuning to the next programmed channel
To tune to the next programmed channel:
Press CH yz on the remote control or TV top panel.
Note:
•This feature will not work unless you program channels into the
TV’s channel memory (see page 36).
• If you use the TV’s remote control to start recording, you will not
be able to change the channel during recording. If you use a
device other than the TV’s remote control to start recording and
then change the channel, the recorded audio and video will be
that of the currently tuned channel.
Tuning to a specific channel
(programmed or unprogrammed)
Tuning analog channels:
Press the Channel Number buttons (0–9) on the remote
control. For example, to select channel 125, press 1, 2, 5.
Tuning digital channels:
Press the Channel Number buttons (0–9) on the remote
control, followed by the – (dash) button and then the sub-
channel number. For example, to select digital channel 125-1,
press 1, 2, 5, –, 1.
Note: If a digital channel is not programmed—either through
the automatic channel scan (page 36) or the channel add/
delete function (page 37)—you will have to tune the RF
channel using the Channel Number and Dash buttons on the
remote control.
Tuning channels (continued)
Switching between two channels using
Channel Return
The Channel Return feature allows you to switch between two
channels without entering an actual channel number each time.
1. Select the first channel you want to view.
2. Select a second channel using the Channel Number buttons
(and the dash (–) button if selecting a digital channel).
3. Press RTN on the remote control. The previous channel
will display. Each time you press RTN, the TV will switch
back and forth between the last two channels that were
selected.
Note: If you press RTN from a non-antenna input, the TV will
return to the last-viewed ANT input and channel.
Switching between two channels using
SurfLock™
The SurfLock™ feature temporarily “memorizes” one channel
in the RTN button, so you can return to that channel quickly
from any other channel by pressing RTN. To memorize a
channel in the RTN button:
1. Select the channel you want to program into the RTN
button.
2. Press and hold RTN for about 2 seconds until the message
“Channel Memorized” appears on the screen. The channel
has been programmed into the RTN button.
3. Continue to change channels until your desired channel is
selected.
4. Press RTN. The memorized channel will be selected. The
TV will return to the memorized channel one time only.
Once you press RTN and then change channels again, the
RTN button memory will be cleared and the button will
function as Channel Return, by switching back and forth
between the last two channels that were selected.
Chapter 8: Using the TV’s features
RTN
Channel Numbers
CH y / z
—
(dash)
#01E_056-064_3237HL95 5/20/05, 2:34 AM60
Black
To Next Page
Loading...
