Toshiba 32HL95 - Scrolling the Theaterwide Picture; (Theaterwide 2 and 3 Only); Using the Auto Aspect Ratio Feature

63
Copyright © 2005 TOSHIBA CORPORATION. All rights reserved.
(E) 32/37/HL95 *Web 213 : 276
Using the auto aspect ratio feature
When the Auto Aspect feature is set to On and one of the
following input sources is received, the picture size is
automatically selected (as described in the table below):
• A 480i signal from the VIDEO 1, VIDEO 2, ColorStream
HD-1, or ColorStream HD-2 input.
• A 480i or 480p signal from the HDMI input.
Note:
•The Auto Aspect feature is not applicable to antenna or Cable input
sources.
•The Auto Aspect feature is not available when the FREEZE mode is
active, or the TV Guide On Screen™ system is open.
To turn on the Auto Aspect feature:
1. Press MENU and open the Video menu.
2. Highlight Theater Settings and press ENTER.
Picture Settings
Advanced Picture Settings
Theater Settings
Video
Navigate
Select
Back Exit
CH RTN EXIT
3. In the Auto Aspect Ratio field, select On.
4. To save the new settings, highlight Done and press
ENTER. To revert back to the factory defaults, highlight
Reset and press ENTER.
Done
Theater Settings
Picture Size TheaterWide 3
Picture Scroll -1
Cinema Mode Film
Auto Aspect Ratio On
Reset
To turn off the Auto Aspect feature:
Select Off in step 3 above.
You can set separate scroll settings for TheaterWide 2 and
TheaterWide 3 modes for each for each input.
To set the scroll settings:
1. Press MENU and open the Video menu.
2. Highlight Theater Settings and press ENTER.
Picture Settings
Advanced Picture Settings
Theater Settings
Video
Navigate
Select
Back Exit
CH RTN EXIT
3. Select which input you want to set the picture size and
scroll setting for.
4. In the Picture Size field, select either TheaterWide 2 or
TheaterWide 3 (you cannot scroll in any other mode).
5. Press z to highlight the Picture Scroll field.
6. Press x • to scroll the picture up and down as needed,
from –10 to +20.
Done
Theater Settings
Picture Size TheaterWide 3
Picture Scroll 0
Cinema Mode Film
Auto Aspect Ratio On
Reset
7. To save the new settings, highlight Done and press
ENTER. To revert back to the factory defaults, highlight
Reset and press ENTER.
Scrolling the TheaterWide
®
picture
(TheaterWide 2 and 3 only)
Automatic aspect size
Aspect ratio
(automatically selected
of signal source
when Auto Aspect is On)
4:3 normal Natural (with side bars)
4:3 letter box TheaterWide 2
16:9 full Full
Not defined
User-selected picture size
(no ID-1 data or )
(see pages 61–62)
HDMI aspect data)
Chapter 8: Using the TV’s features
#01E_056-064_3237HL95 5/20/05, 2:35 AM63
Black