Toshiba 32HL95 - Using Cableclear;DNR (Digital Noise Reduction); Selecting the Color Temperature; Adjusting the Back Lighting Feature

Chapter 8: Using the TV’s features
66
Copyright © 2005 TOSHIBA CORPORATION. All rights reserved.
(E) 32/37/HL95 *Web 213 : 276
Using CableClear
®
/DNR (digital noise
reduction)
The CableClear
®
digital noise reduction feature allows you to
reduce visible interference in your TV picture. This may be
useful when receiving a broadcast with a weak signal (especially
a Cable channel) or playing back a noisy video cassette or disc.
This feature is enabled for 480i signals only.
Note: The CableClear DNR feature does not function in HDMI
(DVI), ATSC, and digital Cable modes.
To select CableClear/DNR preferences:
1. Press MENU and open the Video menu.
2. Highlight Advanced Picture Settings and press ENTER.
3. Press z to highlight the CableClear/DNR field, and then
press • to make a selection.
Note:
• If the current input is Antenna, Video 1, or Video 2, the menu
will display the text “CableClear.” The available selections are
“Off”, “Low”, “Middle”, “High”, and “Auto”.
• If the current input is ColorStream HD1 or ColorStream HD2,
the menu will display the text “DNR.” The available selections
are “Off”, “Low”, “Middle”, “High”, and “Auto”. Auto will react
proportionally to the strength of the noise. “Low”, “Middle”,
and “High”. will reduced the noise in varying degrees with 3
being the highest.
• If the current input is HDMI, the menu will display the text
“DNR” and will be “grayed out” with “Off” selected to indicate
that the feature does not function in this input.
Picture Settings
Advanced Picture Settings
Theater Settings
Video
Done
CableClear Auto
Color Temperature
Back Lighting
Cool
Dynamic Contrast On
MPEG -NR
Low
Reset
ANT 1
Advanced Picture Settings
100
4. To save the new settings, highlight Done and press
ENTER. To revert back to the factory defaults, highlight
Reset and press ENTER.
Adjusting the picture (continued)
Selecting the color temperature
You can change the quality of the picture by selecting from three
preset color temperatures: cool, medium, and warm, as
described below.
To select the color temperature:
1. Press MENU and open the Video menu.
2. Highlight Advanced
Picture Settings and
press ENTER.
3. Press z to highlight
the Color Temperature
field, and then press • to select the mode you prefer (Cool,
Medium, or Warm).
Done
CableClear Auto
Back Lighting
Dynamic Contrast On
MPEG -NR
Low
Reset
ANT 1
Advanced Picture Settings
100
Color Temperature Cool
4. To save the new settings, highlight Done and press
ENTER. To revert back to the factory defaults, highlight
Reset and press ENTER.
Adjusting the back lighting feature
You can use the back lighting feature to adjust the screen
brightness for improved picture clarity.
To adjust the back lighting:
1. Press MENU and open the Video menu.
2. Highlight Advanced Picture Settings and press ENTER.
3. Press z to highlight Back Lighting, and then press x or •
to adjust the screen brightness (0-100).
ANT 1
Advanced Picture Settings
Done
CableClear Auto
Color Temperature
Back Lighting
Cool
Dynamic Contrast On
Reset
100
MPEG -NR
Off
4. To save the new settings, highlight Done and press
ENTER. To revert back to the factory defaults, highlight
Reset and press ENTER.
Mode Picture Quality
Cool blueish
Medium neutral
Warm reddish
Advanced Picture Settings
Picture Settings
Theater Settings
Video
Advanced Picture Settings
#01E_065-072_3237HL95 5/20/05, 2:37 AM66
Black