8
Copyright © 2005 TOSHIBA CORPORATION. All rights reserved.
(E) 32/37/HL95 *Web 213 : 276
1. Carefully read the important safety, installation, care,
and service information on pages 2–5. Keep this
manual for future reference.
2. Observe the following when choosing a location for the
TV:
•
Place the TV on the floor or on the optional TV stand listed in
the “Specifications” section (page 85).
• Place the TV in a location where light does not reflect on the
screen.
• Place the TV far enough from walls and other objects to allow
proper ventilation. Inadequate ventilation may cause
overheating, which will damage the TV. THIS TYPE OF
DAMAGE IS NOT COVERED UNDER THE TOSHIBA
WARRANTY.
• Read “Installation” on pages 3–4.
• Read “Important notes about your LCD TV” on page 5.
3. Do not plug in any power cords until AFTER you have
connected all cables and devices to your TV.
4. BEFORE connecting cables or devices to the TV, learn
the functions of the TV’s connections and controls (pages 9
and 10).
5. Connect your other electronic device(s) to the TV
(pages 12–22).
6. Connect the G-LINK™ cable (either one of the enclosed IR
blaster cables) from your VCR and/or Cable box (if applicable) to
the G-LINK™ terminal so you can use the TV Guide On Screen
™
features (applies to VCRs and cable boxes only). See page 21.
7. Install the batteries in the remote control (page 23).
8. See “Learning about the remote control” (page 28) for
an overview of the buttons on the remote control.
9. Program the remote control to operate your other
device(s) (pages 24–25).
10. AFTER connecting all cables and devices, plug in the
power cords for your TV and other devices. Then press
POWER on the TV top panel or remote control.
“Now Booting...” will be displayed on the screen until the picture
appears.
11. See “Menu layout and navigation” for a quick overview
of navigating the TV’s menu structure (pages 29–30).
12. See Chapter 5 for details on setting up the TV Guide
On Screen™ system (if available in your area).
Note: The TV Guide On Screen™ program guide
opens automatically when you turn on the TV.
To disable this feature, see page 34.
Overview of steps for installing, setting up, and using your new TV
Follow these steps to set up your TV and begin using its many exciting features.
Chapter 1: Introduction
Note:
If you sell or transfer this television to a third party, be sure
to reset the PIN code as described on page 76 under the heading,
“If you cannot remember your PIN code.”
13. See Chapter 7 for details on using the TV Guide
On Screen™ program guide (if available in your area).
•When using the TV Guide On Screen™ system to record a
program for the first time, it is recommended that you
perform a test recording to make sure your system is set up
properly.
• If the TV power cord is unplugged for an extended period of
time, it may take up to 24 hours with the TV in standby
mode (power cord plugged in and power OFF) to download
the entire TV Guide On Screen™ program schedule. Be sure
to follow the instructions under “TV Guide On Screen™
Reminder” on page 34.
14. Program channels into the TV’s channel memory
(page 36).
15. For details on using the TV’s features, see Chapter 8.
16. For help, refer to the Troubleshooting Guide (Chapter
10).
17. For technical specifications and warranty information,
see Chapter 11.
18. Enjoy your new TV!
#01E_007-008_3237HL95 5/20/05, 2:07 AM8
Black
To Next Page
Loading...
