Print this page
Service Mode
Initialization of TV Memory Data
After replacing the Main PC Board, following initialization is required.
1)
ADJUSTMENT
Enter Service Mode.
2)
Select menu of Model ID by pressing P or P during display of adjustment menu in the
service mode.
3)
Confirm if the Model ID data is "0x01". If not, change ID data by pressing + or −.
4)
Press "i+" button on the Remote and hold it down. Then press the P button on the TV
while holding "i+" button.
Initialization process starts, and a message window is shown as the status is "WRITING".
5) After the status changed to "OK", TV turns off and on automatically.
Then the memory initialization is completed.
Enter Service Mode and select Version Check Mode. Confirm if MODEL ID corresponding to
the model name is set correctly. If not, repeat from (2).
Note:
If wrong MODEL ID is set, abnormal display might appear.
6) Check the picture carefully. If necessary, adjust any adjustment item above.
Perform "Auto tune" on the owner's manual.
MODEL ID TABLE
Model Name Model ID (HEX) Panel Vendor
32PB1E/PB1E1/PB1V1 0x02 AUO
TOSHIBA WEB-ZEUS
>> terms and conditions >> privacy policy
Copyright © 1995-2011 TOSHIBA Corporation, All Rights Reserved.
To Next Page
Loading...
