21
SETTING UP YOUR TV
English
To edit the satellite settings:
a In the Satellite Settings menu, press B to highlight
Switch Type.
b Press C or c to select None, ToneBurst, DiSEqC
2way or DiSEqC 4way as your satellite switch type.
c Press b to highlight LNB Power and press C or c to
select On or Off.
To add a transponder:
a In the Satellite Settings menu, press B or b to
highlight the line you want to edit and press OK.
b Press the GREEN button. The Transponder Settings
screen will appear.
c Press B to highlight a new line.
d
Press
OK
.
e
Edit each parameter as required and press
OK
. See
page 21
.
To delete a transponder:
a In the Transponder Settings menu, press B or b to
highlight the line you want to delete.
b Press the RED button.
To edit the Transponder Settings:
a In the Transponder Settings menu, press B or b to
highlight the line you want to edit and press OK.
b Press C or c to select Frequency, Polarisation,
Symbol Rate or S/S2, and set the item using the
number buttons if necessary.
c Press OK to save your settings.
d Repeat steps 1 through 3 for other lines.
e Press BLUE to finish editing and return to Satellite
Settings.
Press GREEN to cancel any edits that were made this
time.
Press YELLOW to reset all transponder settings to
their initial default settings.
To select the Dish Type:
a In the Satellite Settings menu, press B or b to select
the required satellite line, and then press OK.
b Press C or c to highlight Dish and press the GREEN
button.
c Press C or c to select Dish Type. You can select
Movable or Fixed as the Dish Type.
To Next Page
Loading...
