57
CONTROLS AND FEATURES
English
To delete Recording Information
a Press B or b on the Recording Information screen
to select the Recording Information you want to
delete.
b Press the RED button.
Select Yes in the confirmation window that will
appear and press OK.
The selected Recording Information will be deleted.
If scheduled time slots are next to each other and there is
more than one minute between the end time of the first
schedule and the start time of the next schedule,
programmed recording will be performed correctly.
• When Start Padding Time and End Padding Time are set
(see page 55), the start time and end time will be the time
plus the additional minutes.
If scheduling times overlap, priority will be given to the
programmed recording which starts first. When the
programmed recording that started first ends, recording will
switch to the next scheduled programme. At this time,
depending on how far the scheduling times overlap, the
beginning section of the next scheduled programme may not
be recorded.
• When End Padding Time is set for the first programmed
recording (see page 55), depending on how far the
scheduling times overlap, the End Padding Time may be
ignored and recording of the next scheduled programme
may start. As priority is given to the time set in the Set Timer
menu over the Padding Time, recording will automatically
be triggered when the next scheduled programme start
time is reached during End Padding Time.
Camera Sensor Settings
The Camera Sensor can detect a person’s face or movement and
identify individuals by their registered faces. The screen mute and
the standby mode functions by the face detection and motion
detection functions of the Camera Sensor operate, and power
consumption is saved as a result.
a In the Preference menu, press B or b to select
Camera Sensor Setup and press OK.
b Press B or b to select Camera Sensor and press C or
c to select On (to activate the following settings).
c Press B or b to select Camera Sensor Mode and
press
C or c to select Normal or Energy Saving.
d Press B or b to select Time until Picture Off and
press
C or c to select 10min, Test (5sec.)....60min.
(5min.intervals).
NOTE: If the Camera Sensor Mode is in Energy
Saving mode, this feature will be grayed out.
e Press B or b to select Time until Standby and press
C or c to select 5min....60min. (5min.intervals).
f Press B or b to select Test Sensor and press OK to
display Test Sensor screen.
g Press C or c to highlight Face Detected or Motion
Detected.
h Press B or b to highlight Gamma Adjustment and
press
C or c to select the Gamma Adjustment
options Auto, 1, 2, 3, or 4 watching the camera image
on screen.
Scheduling priority
To Next Page
Loading...
