Toshiba 32W300Ps - Picture Quality Settings; Selecting Picture Preference Modes; Adjusting Picture Parameters

24
Selecting the picture preference/
Brightness, Contrast, Colour and Sharpness
Notes:
To reset PICTURE PREFERENCE,
BRIGHTNESS, CONTRAST,
COLOUR, TINT and SHARPNESS
to the factory preset values, select
RESET in step 2, then press ENTER.
The TINT adjustment is only effective
when an NTSC 3.58/4.43MHz signal
is played back through one of the AV
inputs.
•
•
Selecting the picture preference
You can select from four picture preferences ‘Sports, Standard,
Movie, and Memory’ as described in the following table:
1
Press MENU, the menu will
appear on the screen.
Press
or to select
(PICTURE) menu.
EXIT : END MENU: RETURN
PICTURE PREFERENCE
SPORTS
BRIGHTNESS 25
CONTRAST 50
COLOUR 25
TINT 0
SHARPNESS 0
2
Press or to select
PICTURE PREFERENCE, then
press ENTER.
Press
or to select the
mode you prefer.
EXIT : END MENU: RETURN
PICTURE PREFERENCE
SPORTS
BRIGHTNESS 25
CONTRAST 50
COLOUR 25
TINT 0
SHARPNESS 0
SPORTS
Mode Picture Quality
SPORTS Bright and dynamic picture (factory-set)
STANDARD Standard picture quality (factory-set)
MOVIE Movie-like picture setting (factory-set)
MEMORY Your personal preferences (set by you;
see ‘Brightness, Contrast, Colour and
Sharpness’ below)
3
Press EXIT to return to the normal screen.
Brightness, Contrast, Colour and Sharpness
1
Press MENU, the menu will
appear on the screen.
Press
or to select
(PICTURE) menu.
EXIT : END MENU: RETURN
PICTURE PREFERENCE
SPORTS
BRIGHTNESS 25
CONTRAST 50
COLOUR 25
TINT 0
SHARPNESS 0
2
Press or to select
BRIGHTNESS, then press
ENTER.
Then press
or to adjust the
brightness.
Press
or to select
CONTRAST, COLOUR, TINT or
SHARPNESS - these can be
adjusted in the same way.
EXIT : END MENU: RETURN
PICTURE PREFERENCE
SPORTS
BRIGHTNESS 25
CONTRAST 50
COLOUR 25
TINT 0
SHARPNESS 0
25
EXIT : END
BRIGHTNESS
MENU: RETURN
25
The ‘TINT’ menu can only be selected when an NTSC
3.58/4.43MHz signal is played back through one of the
AV channels, and if NTSC or AUTO is selected in the AV
COLOUR setting (see page 29).
3
Press EXIT to return to the normal screen.
32L0141B_Eng.indd 2432L0141B_Eng.indd 24 6/7/2007 9:21:18 AM6/7/2007 9:21:18 AM