Toshiba 36ZP38B - Page 12

– 12 –
GENERAL ADJUSTMENTS
SPECIFIC INFORMATIONS
Items Names
Settings
Input signals Measuring points Adjusting methods Adjusting standards
(User control)
PICTURE MODE-1
Screen size: WIDE
Audio system: I
PICTURE MODE-1
Screen size: WIDE
PICTURE MODE-1
Screen size: WIDE
PICTURE MODE-1
Screen size: WIDE
[RCUT]: 40H
[GCUT]: 40H
[BCUT]: 40H
[GDRV]: 35H
[BDRV]: 35H
Sub-bright signal
(PAL-I Signal)
Sub-bright Signal
Sub-bright Signal
(PAL)
TP46B
Screen adjust-
ment
TP46B
Screen adjustment
쩸 Adjust the amplitude from the pedestal
level to the white peak.
쩸 Adjust the number of collapsed black lines
of the sub-bright signal.
쩹 Adjust this after adjusting W/B, [SCNT].
쩸 Adjust the amplitude of B-Y.
(Apply Y mute at the time of adjustment)
쩸 Enter Horizontal Straight-line Mode.
쩹 Gradually increase the screen VR until R,
G, or B line starts to light up slightly.
쩺 Determine this location as the adjusting
position of the screen VR.
쩻 Gradually raise the respective lines other
than the line that glimmered in  above
and stop at the location where each of
them glimmers.
(Adjust so that it will become almost white)
쩼 Escape from horizontal straight-line mode.
쩽 Use the CA100 and adjust repeatedly so
that both the dark and bright areas will
come to correct values.
2.4 ± 0.1 Vp-p
4±1.5 pieces
Screen adjustment
1.2 ± 0.1 Vo-p
Bright part
(103cd/m
2
)
8750K-0.002uv
Dark part
(17cd/m
2
)
8750K-0.002uv
Screen judgment
(CA100)
[SCNT]
[BRTC]
[COLP]
SCREEN
VR
[RCUT]
[GCUT]
[BCUT]
[GDRV]
[BDRV]
Sub-contrast
Sub-bright
Center
Sub-color center
PA L
R Cutoff
G Cutoff
B Cutoff
G Drive
B Drive
(Reference Factory Adjustments)