1 1 0 UsingtheTV'sAdvancedFeatures
Using the advanced picture settings
2 Highlight Noise Reduction, and then press the ENTER
button.
3
In the CableClear field, select the desired setting. The
available selections are Off. Low. Middle, and High. Low,
Middle, and High will reduce the noise in varying degrees,
from lowest to highest, respectively.
NOTE Ifthecurrentinputis ANT/CABLEorVIDEO,themenuwill display
thetext"CableClear".Ifthecurrentinputis ColorStreamHD,HDMI1
orHDMI2, themenuwill displaythetext "DNR".
4
To save your new settings, highlight Done, and then press the
ENTER button.
To revert to your original settings, highlight Reset, and then
press the ENTER button.
IVlPEGNoise Reduction
The MPEG Noise Reduction feature allows you to reduce visible
interference caused by MPEG compression. Choices for MPEG
Noise Reduction are Off, Low, Middle, and High. Off is
automatically selected when this feature is disabled ("grayed out").
To select the MPEG Noise Reduction level:
1 Press the MENU button and open the Picture menu.
2 Highlight Noise Reduction, and then press the ENTER
button.
3 Press the (A/Y arrow) buttons to highlight the MPEG Noise
Reduction field, and then press the (_/_ arrow) buttons to
select either Off, Low, Middle, or High.
4 To save your new settings, highlight Done, and then press the
ENTER button.
To revert to your original settings, highlight Reset, and then
press the ENTER button.
To Next Page
Loading...
