8 SettingupyourTV
Setting channel skip
4 Open tile Terrestrial menu, highlight Channel Program to
open the Start Scan window, and then press the ENTER
button to begin channel programming.
(Sample Image) Terrestrial menu - Channel Program selection
(Sample Image) Auto tuning p_vgram channels
The TV will automatically cycle through all the antenna channels,
and store all active channels in the channel memory. While the TV
is cycling through the channels, the message "Scanning channels,
please wait" appears.
5 To cancel channel programming, press the EXIT button on the
remote control or highlight Cancel in the on-screen display,
and then press the ENTER button.
When channel programming is complete, press the CH
Up/Down arrow buttons to view the programmed channels.
Settingchannelskip
To prevent a channel from being viewed, you can set it to be
skipped.
1 From the Setup menu, highlight Installation, and then press the
ENTER button.
To Next Page
Loading...
