Toshiba 40E220U - Viewing the Digital Signal Meter

SettingupyourTV 51
Vi_ing the digital signal meter
Mode. Description."
Whenviewingthe HDMI1 input,if digitalaudiofromtheHDMI®
Auto inputisavailable,itwill beoutput.Ifnot,theTVwill automatically
detectandoutputanalogaudiofromthePCAudioinput.
Whenviewingthe HDMI1 input,digitalaudiofromthe HDMI®
Digital inputwill beoutput.
Whenviewingthe HDMI1 input,analogaudiofromthePCAudio
Analog inputwill beoutput.
4 To save the setting, highlight Done, and then press the ENTER
button.
NOTE BecausethePCandHDMI1inputssharethesamesetof analog
audioinputs,the PCAudiomenusettinginfluencestheHDMI1
Audiomenusetting.If PCAudiois setto"No"theHDMI1Audio
settingchangesto "Auto."IfPCAudiois setto"Yes"theHDMI1
Audiosettingis setto "Digital"andisgrayedoutinthemenu.See
"SettingthePCAudio"on page91.
Viewingthedigitalsignalmeter
You can view tile digital signal meter in tile ANT/CABLE digital
TV input source only.
To view the digital signal meter:
1 Press the MENU button to open the Setup menu.
2 Highlight Installation, and then press the ENTER button.
A new set of Installation menu icons appears.
3 Open the Terrestrial menu, highlight Signal Meter, and then
press the ENTER button.
4 Press the (A/Y/,_/_ arrow) buttons to select the antenna input
and digital channel signal you wish to check.
NOTE .:. ThephysicaldigitalchannelnumberlistedintheSignalMeter
screenmaynotcorrespondto avirtualTVchannelnumber.
Contactyourlocalbroadcastersto obtaintheRFchannel
numbersforyourlocaldigitalstations.
¢ Thesignalstrengthdoesnotchangebetweenvirtualchannelson
thesamephysicalchannel.