2 UsingtheTV'sfeatures
Tuning channels using the Channel Blvwser TM
AddingandclearingchannelsandinputsintheHistoryList
Adding channels and inputs to the History List:
As a channel or input is tuned, the Channel Browser TM adds it to the
History List and displays it on the right side of the Channel
Browser TM. Previously tuned channels/inputs are shifted to the left,
eventually moving off the left side. Press the BACK CB arrow
button to surf backward through the previously tuned
channels/inputs. Any channel or input that is tuned repeatedly will
not be repeated in the History List, but instead is moved to the end
of the list on the right side of the Channel Browser TM.
The Channel Browser TM will store the following channels:
o:. All channels that are tuned using the numeric buttons on the
remote control.
°1o All channels that are tuned using the CH Up/CH Down
buttons on the remote control.
NOTE Wheneveranitemis selectedthatcannotbetuned(forvarious
reasons),theTVwill automaticallytuneto thepreviouslyviewed
channelor input.
Clearing channels from the History List:
o:o Reconfiguring the ANT/CABLE input will clear the History
List. see "ANT/CABLE IN" on page 45
o:o Turning off the TV will clear the History List.
Tuningtothenextprogrammedchannel
To tune to tile next programmed channel, press tile CH Up/CH
Down buttons on the remote control or TV control panel.
NOTE This featurewill notfunction until you haveprogramedchannels into
theTV'schannel memory,see"Storing channels in memory
(optional)" on page46.
Tuningtoa specificchannel(programmedor unprogrammed)
To tune analog channels:
*l* Press the Channel Number (0-9) on the remote control. For
example, to select channel 125, press 1,2, 5, and then press the
ENTER button.
To Next Page
Loading...
