UsingtheTV'sfeatures _
Tuning channels using the Channel Browser TM
Tuning digital channels:
€. Press the Channel Number (0-9) on the remote control,
followed by the 100 button, and then tile sub-channel number.
For example, to select digital channel 125-1, press 1, 2, 5, -, 1,
and then press the ENTER button.
NOTE Ifa digitalchannelisnotprogrammed,eitherthroughtheautomatic
channelscanortheChanneladdfunction,see"Addingandclearing
channelsandinputsintheHistoryList"on page62,youwill haveto
tunetheRFchannelusingtheChannelNumbersandthe100button
ontheremotecontrol.
SwitchingbetweentwochannelsusingChannelReturn
The Channel Return feature allows you to switch between two
channels without entering an actual channel number each time.
1 Select the first channel you want to view.
2 Select a second channel using the Channel Number buttons
(and the 100 button if selecting a digital channel).
3 Press the CIt RTN button on the remote control.
The previous channel will display. Each time you press the CIt
RTN button, the TV will switch back and forth between the
last two channels that were tuned.
NOTE IfyoupresstheCHRTNbuttonfromanon-antennainput,theTVwill
returntothelast-viewedinput.
SwitchingbetweentwochannelsusingSurfLockTM
The SurfLock TM feature temporarily "memorizes" one channel to
the CH RTN button, so you can return to that channel quickly from
any other channel by pressing the CH RTN button.
To memorize a channel to the CH RTN button:
1 Tune the TV to the channel you wish to program into the CH
RTN button.
Press and hold the CIt RTN button for a few seconds until the
message "Memorized" appears on the screen. The channel has
been programmed to the CH RTN button.
You can then change channels repeatedly, and when you press
the CH RTN button, the memorized channel will be tuned.
To Next Page
Loading...
